Up
Previous Next

Sheriff CSM™

Changing the Boot Sequence of a Sheriff CSM Hardware

By default, the Sheriff CSM hardware appliance boots from its hard disk. When trying to restore the software on a Sheriff CSM to its factory status, you need to configure Sheriff CSM to boot from the USB drive instead. This section provides instructions for performing this task.

Starting from version 5.4, Sheriff ships Sheriff CSM hardware built on Hewlett Packard Enterprise (HPE) ProLiant Gen9 Servers. All prior versions of Sheriff CSM hardware are built on Supermicro servers. Follow the instructions pertaining to the Sheriff CSM hardware you have.

If the rear view of your Sheriff CSM hardware looks similar to the below, it is built on a Supermicro server.

rear view of USM Appliance All-in-One Supermicro

To configure a Sheriff CSM on Supermicro hardware to boot from a USB drive
  1. Reboot Sheriff CSM, and press Del or Delete to launch the BIOS Setup Utility.

  2. Using the arrow keys, move to Boot.

    BIOS Setup Utility, displaying Boot Settings

  3. On Boot Settings, move the cursor to Boot Device Priority and press Enter.

  4. On Boot Device Priority, move the cursor to 1st Boot Device and select your USB device by using the + and – keys.

    BIOS Setup Utility, displaying Boot Device Priority

  5. To exit, press Esc.

  6. On Exit Options, move the cursor to Save Changes and Exit and press Enter.

  7. Press Enter again to confirm.

  8. Reboot Sheriff CSM.

If the rear view of your Sheriff CSM hardware looks similar to the below, it is built on an HPE ProLiant Server.

DL120 Gen9:

rear view of USM Appliance All-in-One HPE Gen9

DL360 Gen10 with 1Gb interfaces:

rear view of USM Appliance All-in-One HPE Gen10 with 1Gb interfaces

DL360 Gen10 with 10Gb interfaces:

rear view of USM Appliance All-in-One HPE Gen10 with 10Gb interfaces

To configure a Sheriff CSM on HPE hardware to boot from a USB drive
  1. Power on or restart Sheriff CSM.

  2. Press the F9 key, when prompted, to enter System Utilities.

  3. Select System Configuration and then BIOS/Platform Configuration (RBSU).

  4. Select Boot Options and then Legacy BIOS Boot Order, press Enter.

  5. Use the "+" or "-" key to move the USB entry to the top of the boot list.

  6. Press F10 to save your changes.

  7. Restart the server.

Note: The Sheriff CSM Remote Deputy hardware is built on HPE ProLiant DL20 Gen9 Servers, but you can follow the same procedure above to change the boot sequence.

Topic revision: r8 - 08 Sep 2021, SheriffCyberSecurity
Copyright 2020 Sheriff Cyber Security, LLC. All rights reserved.