Up
Previous Next

Sheriff CSMâ„¢

D-Link Wireless Controller

When you configure D-Link Wireless Controller to send log data to Sheriff CSM, you can use the D-Link Unified Wireless Controller plugin to translate raw log data into normalized events for analysis. The table below provides some basic information for the plugin:

Plugin Information

DeviceDetails
Vendor D-Link
Device Type Wireless Security/Management
Connection Type Syslog
Data Source Name Dlink-wireless
Data Source ID 1867

Before you configure the D-Link Wireless Controller integration, you must have the IP Address of the Sheriff CSM Sensor (Deputy).

To configure the D-Link Wireless Controller to send Syslog messages to Sheriff CSM
  1. From the controller's management GUI, select the Tools > Log Settings > Remote Logging option and then go to the Syslog Server Configuration section of the Remote Logging Configuration page.

  2. Enable a syslog server and specify the IP address of the Sheriff CSM Sensor.

  3. Save your changes.
Note: You can specify the granularity of log messages from the wireless controller's Tools > Log Settings > Logs Facility page.

Plugin Enablement

For plugin enablement information, see Enable Plugins.

Additional Resources and Troubleshooting

https://www.manualslib.com/manual/807482/D-Link-Dwc-1000.html?page=336#manual

For troubleshooting, refer to the vendor documentation:

https://www.manualslib.com/manual/451489/D-Link-Dwc-1000.html?page=211
Topic revision: r9 - 06 Jul 2022, SheriffCyberSecurity
Copyright 2020 Sheriff Cyber Security, LLC. All rights reserved.