UpPrevious Next
Sheriff CSMâ„¢
Array Networks Secure Access Gateway
When you configure Array Networks Secure Access Gateway to send log data to Sheriff CSM, you can use the Array Networks Secure Access Gateway plugin to translate raw log data into normalized events for analysis. The table below provides some basic information for the plugin:
Plugin Information
Device | Details |
Vendor | Array Networks |
Device Type | Network Access Control |
Connection Type | Syslog |
Data Source Name | Array-networks-sag |
Data Source ID | 1906 |
Integrating Array Networks Secure Access Gateway
Before you configure the Array Networks Secure Access Gateway integration, you must have the IP Address of the Sheriff CSM Sensor (Deputy).
To configure Array Networks Secure Access Gateway to send Syslog messages to Sheriff CSM
From the Array Networks CLI client, insert the following command:
AN(config)# log host x.x.x.x 514 udp 0 all## Replace x.x.x.x with the Sheriff CSM Sensor IP Address
where the syntax of the command statement is as follows:
log host
<host_ip> [port] [protocol] [host_id] [log_level]
Plugin Enablement
For plugin enablement information, see
Enable Plugins.
Additional Resources and Troubleshooting
http://oss.aliyuncs.com/netmarket/commodity_user_guide/ff38177d-aaa6-42a2-ba99-03e9c7f496f5.pdf
For troubleshooting, refer to the vendor documentation:
https://support.arraynetworks.net/prx/000/http/localhost/help