Up
Previous Next

Sheriff CSM™

D-Link Wireless Controller

When you configure D-Link Wireless Controller to send log data to Sheriff CSM, you can use the D-Link Unified Wireless Controller plugin to translate raw log data into normalized events for analysis. The table below provides some basic information for the plugin:

Plugin Information

Device	Details
Vendor	D-Link
Device Type	Wireless Security/Management
Connection Type	Syslog
Data Source Name	Dlink-wireless
Data Source ID	1867

Integrating D-Link Wireless Controller

Before you configure the D-Link Wireless Controller integration, you must have the IP Address of the Sheriff CSM Sensor (Deputy).

To configure the D-Link Wireless Controller to send Syslog messages to Sheriff CSM

1. From the controller's management GUI, select the Tools > Log Settings > Remote Logging option and then go to the Syslog Server Configuration section of the Remote Logging Configuration page.

   

2. Enable a syslog server and specify the IP address of the Sheriff CSM Sensor.

3. Save your changes.

Note: You can specify the granularity of log messages from the wireless controller's Tools > Log Settings > Logs Facility page.

Plugin Enablement

For plugin enablement information, see Enable Plugins.

Additional Resources and Troubleshooting

https://www.manualslib.com/manual/807482/D-Link-Dwc-1000.html?page=336#manual

For troubleshooting, refer to the vendor documentation:

https://www.manualslib.com/manual/451489/D-Link-Dwc-1000.html?page=211